Sunday, March 2, 2014
How to Change an Auto Ignition Lock
An automobile is a combination of various parts working in perfect harmony, with the goal of delivering comfort and utility to its owner. Your vehicle requires proper maintenance to operate efficiently. The ignition lock is one of many heavily used components on an auto; eventually, wear and tear takes a toll and the lock will need to be replaced. The procedure is simple and once it is replaced, your new ignition lock will provide reliable service for years to come.
Instructions
- 1
Park your vehicle in "Neutral" and set the parking brake. Open the hood and disconnect the negative cable from the battery using a wrench.
2Locate the screws holding the steering cover in place. The steering cover consists of two halves fastened together with a pair of Phillips screws; the screws are located on the underside of the steering column. Use a flashlight if you need more light to see the screws. Remove the screws with the Phillips screwdriver. Remove both sections of the steering cover to expose the cylindrical ignition lock.
3Remove the screws holding the ignition lock in place using a flat-head screwdriver. Be caul not to damage the wiring connected to the lock through the wire grip. On some vehicles, a bolt secures the ignition lock and youll use a socket wrench to remove this bolt.
4Remove the ignition lock caully. Once unscrewed, it will slide out easily. Detach the wire grip connecting the lock to the vehicles electrical system. Discard the old ignition lock.
5Connect the wire grip to the new ignition lock. The wire grip is fragile so handle it caully.
6Reconnect the negative battery cable and test the new ignition lock. Turn the key from "Off" to "On" several times. If the ignition lock turns smoothly and performs as expected, start the car several times.
7Disconnect the negative battery cable again with a wrench before proceeding.
8Secure the new ignition lock in place. The wires leading to the wire grip may be different lengths so you may need to maneuver the lock to avoid crimping the wires.
9Fasten the ignition lock in place using the Phillips screwdriver to tighten the screws you removed earlier. Reattach the steering cover, starting with the lower half and then the top. Tighten the Phillips screws to secure the steering cover in place.
No comments:
Post a Comment