Thursday, October 17, 2013
How to Replace the Fuel Line in a 2005 Ford Thunderbird
The Ford Thunderbird was introduced in 1955 and, over the ensuing years, this popular car went through eleven generations. The 2005 Thunderbird is a two-seat convertible powered by a V-8 engine with an output of 280 horsepower and 286 foot-pounds of torque. The engine is paired with a five-speed automatic transmission. The fuel lines on this car are prone to develop leaks if the lines rub against any metal parts under the car. Once that happens, the fuel lines need to be replaced.
Instructions
- 1
Make sure the Thunderbird is in neutral and lift it on a hoist. Release the fuel system pressure by opening the gas cap. Disconnect the ground cable from the battery using a wrench. Remove the left front wheel using the torque wrench and then remove the splash shield using a flat-head screwdriver.
2Disconnect the fuel hose safety clip and spring lock coupling using a flat-head screwdriver. Disconnect the two vapor tubes and then the quick-release fittings from the evaporative canister purge valve. Remove the fuel-tube mounting bolt using the correct size socket. When re-installing this bolt, torque to 71 inch-pounds.
3Disconnect the fuel-tube quick release fittings from both sides of the fuel filter. Remove the fuel filter bracket mounting bolt using a socket. Remove the fuel filter bracket and fuel filter by simply turning it counterclockwise. When reassembling, tighten to 62 inch-pounds with the appropriate socket. Remove the fuel tube shield mounting bolt with the torque wrench. When re-installing, tighten to 44 inch-pounds. Remove the three fuel tubes, the shield mounting fasteners and the fuel tube shield with a flathead screwdriver. When reassembling, tighten to 44 inch-pounds.
4Disconnect the fuel tube quick release fitting from the fuel tank supply tube. Disconnect the vapor tube quick release fitting from the fuel vapor control tube assembly valve. Remove the four fuel tubes, the mounting bolts and the fuel tube assembly with the socket. When reassembling, tighten these bolts to 62 inch-pounds using the socket. Fit in the new fuel tubes. To reassemble, follow the above steps in reverse.
Thursday, September 19, 2013
How do I Troubleshoot a Weedeater Line Feed
A weedeater, whether electric or gas powered, is a modern convenience. Gone are the days of pulling weeds by hand, or clipping them with a pair of hand shears. But weedeaters can have their problems, and knowing how to fix them is essential to using the weedeater in the most productive way possible. The most common problem with a weedeater is with the line that is fed from the head and does the actual cutting.
Instructions
- 1
Ensure that the ports that dispense the line are free of debris. Sometimes small stones or a buildup of weeds and grass can clog the ports, preventing the line from feeding properly. Use a screwdriver to remove any debris from the ports. Try the weedeater again.
2Turn the weedeater over and remove the hub if the weedeater is still having problems. On most models the hub can be removed by hand by pushing down and twisting. Usually there are instructions on the hub for its removal. With the hub removed you will have access to the cutting line.
3Remove the line spool and remove the line from the spool. There may be knots or entanglements which are preventing the line from feeding correctly. Rewrap the line on the spool and reinstall. If there is little or no line on the spool, purchase a new spool from a home improvement store and install it on the weedeater.