Showing posts with label feed. Show all posts
Showing posts with label feed. Show all posts

Friday, December 6, 2013

How to Adjust the DeVilbiss Gravity Feed HVLP Gun for Enamel

How to Adjust the DeVilbiss Gravity Feed HVLP Gun for Enamel

DeVilbiss gravity feed spray guns are designed the same way that other spray guns are; in order to paint using a DeVilbiss HVLP gun you must adjust them for air pressure, flow rate of material and spray pattern. Making these adjustments to the gun will allow you to properly spray any paint, including enamel paint, when it has been properly thinned.

Instructions

    1

    Plug the air compressors air line into the base of the DeVilbiss spray gun; it has a universal fitting that locks into the air line. You will see the air pressure gauge at the base of the gun register the overall air pressure from the compressor when the line is properly inserted.

    2

    Adjust the knob at the base of the DeVilbiss spray gun until the dial indicator registers 20 pounds per square inch. This is the optimum spraying pressure for enamel paint.

    3

    Pull the trigger of the spray gun. The trigger should pull back within 1/2-inch of the handle. The spray adjustment knob is located at the top and the back of the spray gun; turning the knob counterclockwise will reduce the amount of play in the spray guns trigger, thus reducing the amount of paint allowed into the sprayer.

    4

    Locate the knob on the side of the spray gun. On a DeVilbiss HVLP, this knob controls the width of the spray pattern of the gun. Adjust this knob all the way counterclockwise to open the spray pattern all the way.; at this setting, when spraying 12 inches from the surface, the spray pattern will be 12 inches wide.

    5

    Locate the knob just above the webbing of your thumb and forefinger when holding the spray gun; this knob controls the air pressure of the gun. Turn the knob all the way clockwise to open up the gun completely. Because you have a pressure reading of 20 PSI from the air control knob, you do not need to further restrict the air flow.

    6

    Thin the enamel paint with a 4:1 ratio of paint to enamel thinner; this is the accepted standard for spraying enamel paint through a 20 PSI spray gun. You should doublecheck the paint data sheets to make certain, though, as some paint manufacturers may produce their paint slightly thicker or thinner, and will recommend a different optimal pressure accordingly.

Read More.. >

Thursday, September 19, 2013

How do I Troubleshoot a Weedeater Line Feed

A weedeater, whether electric or gas powered, is a modern convenience. Gone are the days of pulling weeds by hand, or clipping them with a pair of hand shears. But weedeaters can have their problems, and knowing how to fix them is essential to using the weedeater in the most productive way possible. The most common problem with a weedeater is with the line that is fed from the head and does the actual cutting.

Instructions

    1

    Ensure that the ports that dispense the line are free of debris. Sometimes small stones or a buildup of weeds and grass can clog the ports, preventing the line from feeding properly. Use a screwdriver to remove any debris from the ports. Try the weedeater again.

    2

    Turn the weedeater over and remove the hub if the weedeater is still having problems. On most models the hub can be removed by hand by pushing down and twisting. Usually there are instructions on the hub for its removal. With the hub removed you will have access to the cutting line.

    3

    Remove the line spool and remove the line from the spool. There may be knots or entanglements which are preventing the line from feeding correctly. Rewrap the line on the spool and reinstall. If there is little or no line on the spool, purchase a new spool from a home improvement store and install it on the weedeater.

Read More.. >