Tuesday, April 22, 2014
When Is it Time to Replace Compressed Air Hoses
Compressed air hoses are powerful tools for workers in a variety of industries. While their power can speed up the pace of work, they can be extremely dangerous if used past their prime. A few key signs indicate when it is time to replace a compressed air hose.
Kinking
If a compressed air hose is permanently kinked, it is time to replace the hose. A backup of compressed air at the kinked area could lead to an explosion, which could be deadly.
Fraying or Cracking
The fraying of the protective fabric surrounding a compressed air hose -- or the cracking of the rubber if no fabric is present -- is a sign that the compressed air hose needs to be replaced. The rapid escape of compressed air from a hole in the hose can cause serious injury to workers and bystanders.
Bending
If a compressed air hose is bent, it needs to be replaced as soon as possible. Bending of a compressed air hose can drastically alter the air flow and potentially create an accident leading to serious injury.
Pressure Ratings
Each compressed air hose is rated to withstand a maximum pounds per square inch in air pressure. If a compressed air hose is not rated to withstand the compressor it is fitted to, it is time to replace the hose.
Maintenance
Compressed air hoses should be cleaned regularly using soapy water, not kerosene or other flammable material. After cleaning, make sure the compressed air hose is completely purged. While doing maintenance work on the compressed air hose, make sure the compressor or other equipment is attached to is turned off.
Saturday, November 30, 2013
How to Time a Harley Davidson Motorcycle
Checking the timing on your Harley-Davidson motorcycle every 5,000 miles plays an important role in a comprehensive maintenance routine. As a Harley-Davidson engine ages, you must adjust the ignition timing to compensate for the wear of internal engine parts. Setting the timing correctly keeps your motorcycle running smoothly and efficiently. Maladjusted timing may result in sluggish performance, poor fuel economy and possible damage to internal engine components. Setting the timing is relatively easy and ensures the maximum life from the engine.
Instructions
- 1
Remove the crankcase timing plug using an Allen wrench, and expose the timing hole. The timing hole is located on the primary chain case side of the motor on the engine block and capped with a solid hex-head plug. Install a clear plastic timing hole plug to prevent oil splash.
2Connect the positive terminal of an inductive timing light to the positive battery terminal of the motorcycle. Connect the negative terminal of the timing light to the negative terminal of the battery. Connect the inductive pickup probe of the timing light to the front cylinder spark plug wire.
3Start the engine, and run it at idle. Point the timing light into the timing inspection hole. If the ignition is properly timed, the timing bar will align with the circular timing reference mark. The reference marks on a correctly timed engine will appear as a vertical bar through the center of the circle. Some models only have a timing reference mark on the flywheel of the motor; on these models, the engine is correctly timed when the reference mark is visible in the timing inspection hole.
4Remove the timing cover from the right side of the motor with a Phillips screwdriver or Allen wrench, depending on your specific model. Loosen the the timing plate screws with a slotted screwdriver, and turn the timing plate to adjust the timing. Recheck the timing marks with the timing light. Tighten the timing plate screws, and install the cover.
5Shut off the engine, and remove the timing light. Remove the clear plastic timing hole plug, and install the solid plug in the hole.