Thursday, March 6, 2014
Where Is the Fuel Pump on a 1990 Trans Am
A faulty fuel pump in a 1990 Trans Am will leave you stranded on the side of the road. Its job is to deliver fuel from the tank to the engine at the correct pressure. Changing a fuel pump can be a challenging repair as it is often located in a difficult area to reach.
Fuel Pump Identification
The fuel pump in a 1990 Trans Am is similar in shape to a soda can, with two gas lines and one electrical connection on the top.
Type of Fuel Pump
The 1990 Pontiac Trans Am uses an electric fuel pump that is common in fuel-injected vehicles. An electric pump can deliver a higher pressure of fuel more consistently.
Fuel Pump Location
The fuel pump in your 1990 Pontiac Trans Am is inside the fuel tank at the rear of the vehicle.
Reason for Location
The Pontiac Trans Ams fuel pump is located inside the fuel tank for safety reasons. By placing the pump in a cool liquid, well away from an ignition source, it reduces the chances of fire.
Saturday, December 7, 2013
How to Take a Catalytic Converter Off a 2000 Grand Am SE 3400
The Pontiac Grand Am SE came standard with a 150-horsepower, 2.4-liter four-cylinder engine, but did have an optional 170-horsepower, 3.4-liter V-6 engine, which some people know as the 3400 V-6. The 2000 Grand Am SE used a muffler-like component, the catalytic converter, to convert the toxic gasses in the exhaust to less harmful ones. Replacing the cat on the 2000 Grand Am SE 3400 is a straightforward task, thanks to the vehicles simple exhaust design.
Instructions
Removal
- 1
Allow the vehicle to sit until the engine is cool to the touch, then allow it to sit for an additional hour to allow the exhaust and catalytic converter to cool completely.
2Lift the front of the Grand Am with a floor jack and slide jack stands under its subframe. Lower the vehicle onto the jack stands.
3Crawl under the center of the vehicle and find the catalytic converter-and-front pipe assembly. Position a pair of jack stands under the catalytic converter-and-front pipe assembly to support it.
4Remove the three bolts securing the catalytic converter-and-front pipe assembly to the intermediate pipe -- the pipe to the rear of the catalytic converter -- using a ratchet and socket.
5Unfasten the two bolts securing the catalytic converter-and-front pipe assembly to the exhaust manifold crossover pipe, which is the pipe connecting the front and rear exhaust manifolds, using a ratchet and socket. Slowly lower the catalytic converter-and-front pipe assembly and remove it from the vehicle.
6Pull the old gaskets from the crossover and intermediate pipes, if needed, and scour the mating surfaces of both pipes with a wire brush.
Installation
- 7
Crawl under the vehicle with the catalytic converter-and-front pipe assembly in hand and set the assembly on the jack stands to hold it in place.
8Line up the bolt holes in the catalytic converter-and-front pipe assemblys front-most flange with those in the crossover pipes flange. Slide a new gasket between the flanges, aligning the gaskets bolt holes with those in the flanges, and hand-tighten the two retaining bolts.
9Align the bolt holes on the catalytic converter-and-front pipe assemblys rearmost flange with those on the intermediate pipes flange. Slide a new gasket between the flanges, aligning the bolt holes in the gasket with those in the flanges, and hand-tighten the bolts.
10Tighten all five of the catalytic converter-and-front pipe assemblys retaining bolts to 25 foot-pounds using a torque wrench and socket.
11Raise the Grand Am off the jack stands and remove the stands. Lower the vehicle to the ground.