Find solution

Fixing a catalytic converter is a complicated process because of the laws that govern virtually every aspect of installing, maintaining and replacing catalytic converters. The Environmental Protection Agency issued regulations in 1986 that make it illegal to tamper with your vehicles catalytic converter in any way, shape or form. Any repairs made to a vehicles catalytic converter have to be performed and properly documented by a certified mechanic.

Instructions

1

Take your Tundra to an emissions testing facility or exhaust repair shop and have your catalytic converter tested. You have to be able to document that your Tundras converter has stopped working before you are legally allowed to have it replaced.

2

Make sure that your Toyota is no longer covered by the federal emissions warranty. If your 2000 Toyota Tundra does not have 80,000 miles on it yet, then Toyota is required to replace the converter at no cost to you. If your Tundra is still under warranty, take it to your nearest Toyota dealership for repairs.

3

Take the Tundra to the dealership or exhaust repair shop (if it is not already there) and provide them with documentation that the converter is bad. Legally, they are only allowed to replace your converter with a catalytic converter that is the same as the one currently installed on your Toyota. Have the shop replace the catalytic converter. Make sure the shop fills out and submits the warranty card for the new converter, as it is legally required by federal law.

4

Save all documentation relating to the converter swap. If your Tundra has a problem with the catalytic converter or fails an emissions test in the future, you may need this information to get repairs performed and avoid possible fines.

The Toyota Tundra is the largest of the companys truck line. So, when making repairs or enhancements, its good to use the right tools and equipment to keep the vehicle in top shape. Whether its wrenches for that tough job or a scanner to check the system computer, there are a variety of tools to get the job done.

Body Repair Kit

The Tundra utilizes a body-repair kit used for repairing sheet metal on flat and curved surfaces. Each set includes a pick and finish hammer, shrinking hammer, and straight finishing hammer. The kit comes in a storage case and carries a lifetime replacement warranty.

Bumper Lift

A bumper lift is used with a jack to lift the back of a Tundra. The lift capacity is 3,000 pounds, raising the Tundras bumper up to two inches. The bumper lift is used with a hi-lift jack. The goal of the bumper lift is to raise the bumper to provide additional protection for the Tundra body.

Wrench Set

A Tundra wrench set is used for everything from changing breaks to changing oil and filter to tighten loose parts. The 22-piece wrench set is made of polish chrome steel and has a plastic rack for storage. Features include a lifetime replacement warranty and standard and metric sizes, Standard sizes range from 1/4-inch to 7/8-inch sizes. Metric wrenches vary from 9 mm to 19 mm sizes.

PocketScan Plus

PocketScan Plus is a computer diagnostic scanner for Tundra and similar trucks. The scanner displays OBD II code definitions. The OBD II codes are generated by on-board computer diagnostics. The scanner clears the codes after identifying the problem. The scanner provides the cars vehicle ID number and freeze frame data. An OBD II cable is included.