Showing posts with label switch. Show all posts
Showing posts with label switch. Show all posts

Monday, November 17, 2014

Where Is the Fuel Pump Switch on a 1991 Ford Explorer

The fuel pump switch is also known as the inertia switch, a device that prevents fuel from going to the engine if your 1991 Ford Explorer happens to get into a collision. It also enables the fuel pressure to be relieved.

Location

    The inertia switch can be found mounted on the floor pan on the passenger side inside your Explorer; look below the heater unit. It will have an electrical connector attached to it.

Servicing the Fuel System

    Disconnect the electrical connector that is attached to the inertia switch when performing a task such as relieving the fuel pressure on your Ford Explorer. Whenever youve finished servicing the fuel system, reattach the electrical connector to the switch. You do not need any tool for removing and attaching the connector.

Reset Button

    The inertia switch also has a reset button at the top to use in the event the switch was activated during a procedure like relieving the fuel pressure, which would create a popping-like sound. Simply push the button to reset the switch if this occurs.

Read More.. >

Wednesday, October 9, 2013

How to Test an 88 Cherokee Ignition Switch

The ignition switch in your 88 Cherokee carries the signal that is initiated by the operator of the vehicle to the starter. The starter then turns over the engine and starts your Cherokee. If you have been encountering difficulty when you go to turn over your engine, you should perform an ignition switch test. If you can no longer maintain a continuous flow of power to the interior lights, gauges or radio in your Cherokee, you should also perform this test to help you diagnose potential problems with the switch.

Instructions

    1

    Locate the fuse block below the dash on the left side of the brake and clutch pedals.

    2

    Pull the plastic cover off the fuse block and locate the fuse for the ignition; it is the first fuse on the top left side of the fuse block.

    3

    Pull the fuse straight out to unplug it from the fuse block.

    4

    Inspect the fuse for damage. If you notice corrosion at the metal base piece of the fuse, replace it with a new fuse.

    5

    Prop open your hood and rotate the multimeters knob until it sits at the "Volts" setting. A multimeter measures electrical voltage, current and resistance through digital or analogue meters. Some multimeter models additionally read temperatures, inductance, frequencies, capacitance and duty cycles.

    6

    Hold the red probe on the multimeter to the positive port on your battery. Hold the black probe on the multimeter against the frame of your Cherokee. A working battery will provide a voltage reading of 12.6 volts on the multimeter. If you read any voltage amount less than 12.6 volts, replace your battery.

    7

    Insert your key into the ignition switch and turn it to start your engine. If the engine starts, you do not have a problem with the ignition switch. If your engine does not start, listen for a single-click sound as you rotate the key to the "III" mark. If you do not hear this sound, you need to replace the ignition switch because it is broken.

Read More.. >