Showing posts with label terminal. Show all posts
Showing posts with label terminal. Show all posts

Wednesday, May 21, 2014

How to Repair a Battery Side Post Terminal

How to Repair a Battery Side Post Terminal

Side post battery terminals are common in some car models, such as General Motors. When corrosion builds up on one or both of the terminals, it can cause interference in the flow of electricity to the vehicle. The result will be a car that wont start. You can prevent this from happening with the simple repair of removing the corrosion from the battery terminal post. Always be sure to follow any additional instructions provided by your vehicles manufacturer.

Instructions

    1

    Put on the safety glasses and gloves.

    2

    Unscrew the battery cable clamps from the side battery posts terminal with the adjustable socket wrench. Start with the negative battery cable first, then the positive battery cable. Secure the cables out of the way so they will not flop back and come into contact with the terminal posts.

    3

    Apply the detergent or a paste made from baking soda and water to each battery terminal post. Scrub with the wire brush to remove corrosion.

    4

    Rinse with water, taking care not to get any water in the battery vents. Dry thoroughly with a clean, lint-free cloth.

    5

    Apply a thin coat of petroleum jelly to each of the side battery terminal posts.

    6

    Reattach the positive cable to the positive post, first with your hand and then with the socket wrench. Repeat to reattach the negative cable to the negative post.

Read More.. >

Saturday, September 28, 2013

How to Install a Battery Terminal

How to Install a Battery Terminal

A cars battery connects to the vehicle through the terminals, which are the sleeves that fit over the battery posts. Acid and rust degrade the terminals, which, if not monitored, will cause the terminals to fracture and break. The wiring to the terminals is typically covered with rubber, protecting it from exposure to acid and water. Replacing the terminal is similar to splicing a line and only requires a few tools to complete.

Instructions

    1

    Disconnect the terminals from the vehicles battery starting with the negative terminal. Use a ratchet to loosen the terminal then pull it free from the battery.

    2

    Cut the damaged wire and terminal off with bolt or wire cutters. Cut the wire just behind the existing rubber sleeve to remove any corroded parts of the wire.

    3

    Use a razor blade or utility knife to trim off 1 inch of rubber from the rubber sleeve. Slice the rubber along its length then slide the rubber around the circumference of the wire. Pull the rubber off to expose the clean wire.

    4

    Place the wire into the new terminal retaining bolts. You have a few options for replacement terminals. The easiest to use will have the retaining bolts that tighten down onto the wire with a ratchet. The other types require specialized crimping tools to grab the wire. Tighten the retaining bolts until the wire cannot be pulled from the new terminal.

    5

    Install the terminals back onto the battery, starting with the positive connection. Make sure the terminals are pushed all the way onto the battery posts. Tighten down the terminals until they are secure.

Read More.. >