Showing posts with label rv. Show all posts
Showing posts with label rv. Show all posts

Thursday, April 24, 2014

How to Repair RV Springs

How to Repair RV Springs

Traveling in an recreational vehicle (RV) is a fun and enjoyable way to see the country. RVs are stocked with everything you need to live on the road; as such, they have toilets and showers, beds and furniture, rigerators, stoves and, yes, even the proverbial kitchen sink. All these household items make an RV weigh a lot, which in turn places greater wear on an RVs suspension components. The suspension part that gets the most abuse is the coil spring, as it is constantly being torqued while the RV is in motion and under constant stress from the weight of the RV itself.

Instructions

    1

    Raise your RV with an RV jack. Do not use a normal car jack, as the greater weight of a RV can break a car jack. Lift the RV up until the wheel whose suspension you want to work on is no longer in contact with the ground and rotates freely. Once the wheel is in the air, if the RV suspension spring has broken in half or more, you can remove the pieces by hand, as the springs are normally held in place via the pressure of the RV on the spring itself. Use work gloves to remove the spring, as the spring may have ragged metal edges if it has broken.

    2

    Remove the RV wheel with a nut removal tool; your RV should have come with one. If you need additional torque, use a power tool with a nut-removal bit. Be caul when removing the wheel, as RV wheels can weigh substantially more than car wheels depending upon your RVs make and model.

    3

    Remove the brake pad assembly with a Phillips-head screwdriver. Some RVs may use a drum assembly; you still use a Phillips-head screwdriver to remove it. Caully support the brake assembly when removing it, as its weight can rip off the brake lines. Just set the brake assembly on a stool, elevated, so that you do not have to go through the hassle of flushing the brake system and reattaching lines.

    4

    Remove the spring by pulling down on the control arm to its full extension and wedging a flat-head screwdriver between the suspension arm and the spring. Wiggle the coil off with back-and-forth rocking motions. Wear safety goggles in case the spring jumps off the control arm.

    5

    Replace the spring with a new spring by again pulling the control arm down to its fullest extension, with a flat-head screwdriver as a wedge. The spring will naturally push into place around the attachment point. Reattach the brake assembly, then wrench the wheel back on.

Read More.. >

Sunday, December 1, 2013

How to Troubleshoot a Coleman RV A C

How to Troubleshoot a Coleman RV A/C

Coleman Recreational Vehicles are used for camping and cross-country trips. If youre having problems with your Coleman RVs air conditioning, there are a few things you can do before you take it to a technician. If your RV requires a major repair, its best to take it to a repair shop. Minor problems can be fixed with little hassle. You dont have to be a mechanic to get your air conditioning working again.

Instructions

    1

    Turn on the engine to your Coleman RV. Turn on the air conditioning from the control panel on the front console. Turn the temperature setting all the way down.

    2

    Put your hand to the vent to see if air is coming through the system. If air is coming through hot, you have probably lost some refrigerant in the system. If there is no air coming through the vent, have a professional take a look at your unit.

    3

    Pop the hood on your Coleman RC and look over the air conditioning compressor. The compressor is on the left side of the engine. Locate the compressor belt on the unit. Make sure the belt isnt damaged or worn. If the belt is worn or broken, replace it.

    4

    Remove the low pressure side cap of the compressor. The low pressure side is the smaller of the two steel lines. The cap should be blue. Connect a pressure gauge to the low side.

    5

    Check the gauge to make sure that your pressure level is within the Green band. If the pressure level is within the green, your AC unit is fully charged. If the air conditioner isnt working and youre in the green, the compressor is dead.

    6

    Have the air conditioning unit serviced by a professional if the gauge isnt in the green. This means that your system is not fully charged. Have a technician charge your system.

Read More.. >