Showing posts with label doesnt. Show all posts
Showing posts with label doesnt. Show all posts

Friday, April 4, 2014

How to Open the Trunk of a Car When a Key Doesnt Work

How to Open the Trunk of a Car When a Key Doesnt Work

Most cars built today offer multiple ways to access the trunk. Remote controls, keys and manual trunk releases all allow access to the trunk compartment. When one or more of these methods becomes impossible due to a bad or lost key, accessing the trunk can be more of a challenge. However, there are ways to get into the trunk in desperate situations.

Instructions

    1

    Locate the trunk release button or latch located near the driver seat. Most current vehicles have a manual trunk release. The release is usually located on the left floorboard near the driver seat, on the driver door below the armrest area or on the dashboard to the left of the steering wheel.

    2

    Fold down the back seat to access the trunk area and crawl into the trunk and pull the manual safety release. All vehicles built since 2002 are required to have a glow-in-the dark manual safely release in the trunk to prevent children or others from being accidentally locked in.

    3

    Contact a locksmith or your auto dealer. A locksmith will be able to pop open the lock and may be able to get a new key made for the lock. A dealership may be be able to create or order a new key if provided the vehicle identification number and proof of ownership. If the passenger compartment is also locked and inaccessible, contacting the dealer or a locksmith will help prevent damage being caused to the vehicle during attempts to get inside.

Read More.. >

Monday, September 30, 2013

When I Turn on the Air Conditioner the Fan Blows But the Outside Compressor Doesnt Come On

When I Turn on the Air Conditioner the Fan Blows But the Outside Compressor Doesnt Come On

Since its introduction to the automotive world in the 1940 Packard, air-conditioning systems have been through many changes. The most drastic change was the shift from R12 to R134a, due to environmental concerns. When you turn on the air conditioner by pressing the power button and turning on the fan, you expect to hear the compressor kick on. There are six main reasons for the compressor not to turn on when you expect it to.

Incorrect Charge Level

    All air-conditioning systems use a refrigerant to cool the cabin of the vehicle -- either R134a or R12. All post-1996 vehicles use R134a and prior to that, most vehicles used R12 refrigerant, commonly called Freon. The air-conditioning system requires a specific amount for refrigerant to run without causing damage. If the charge is low, most cars cut off power to the compressor to keep it from turning on.

Failed Pressure Sensor

    Air-conditioning systems are under high pressure -- some exceed 200 psi. If the system has too much or too little pressure, damage may occur. Most modern vehicles use an air-conditioning pressure switch to monitor the pressures and cut power to the compressor if the pressures are incorrect. If this switch fails, no power can get to the compressor and it will not turn on.

Failed Wiring

    The air-conditioning systems in all cars have a series of power and ground wires. If one of these wires fails, the compressor cannot receive power and will not turn on. This failed wiring can also cause additional problems with your vehicle.

Failed Air Conditioning Switch

    To engage the air conditioner, you must press a switch inside the vehicle. If the electronics inside this button fails, the compressor will not turn on, as it will not receive power.

Blown Fuse

    As with all electric systems in vehicles, there is a fuse that protects the compressor from power overload, typically 10 to 30 amps. If the amperage exceeds the limits of the fuse, it will break the circuit and the compressor will no longer receive power.

Failed Compressor

    The compressor has a clutch on the front that engages and disengages as you turn the air conditioning on and off. If this clutch fails, it causes the compressor to either lock up or spin freely. If the latter is true, the compressor cannot turn on, as the power is not transferring from the drive belt to the compressor. If the former is true, the pulley locks up with the compressor and you will hear a loud screeching sound from the belt spinning on the stuck pulley.

Read More.. >