Showing posts with label come. Show all posts
Showing posts with label come. Show all posts

Wednesday, April 23, 2014

My Front Wheel Hub Wont Come Off

My Front Wheel Hub Wont Come Off

The front wheel hub keeps the rim and tire attached to a car with lug nuts. The problem with the front wheel hub is that the rim can become oxidized in place. This can make for an annoying tire change if you run into problems. Getting your wheel off the wheel hub is not very hard to do. You dont have to take your car into a service shop to perform this task. You can do it yourself with little hassle.

Instructions

    1

    Jack the car up from the front end so the wheel hub is lifted off the ground. Remove the lug nuts from the rim with a tire iron. Keep the lug nuts together so they arent lost.

    2

    Spray a penetrating lubricant like WD-40 onto the entire wheel hub. Make sure that the lubricant seeps into the cracks under and around the connection from the wheel to the wheel hub.

    3

    Use a pry bar to remove the wheel from the car. Insert the pry bar into the crack where the wheel meets the hub. Put pressure on the pry bar until you feel the wheel coming loose from the hub.

    4

    Use the pry bar all around the wheel until it comes free from the wheel hub.

Read More.. >

Monday, September 30, 2013

When I Turn on the Air Conditioner the Fan Blows But the Outside Compressor Doesnt Come On

When I Turn on the Air Conditioner the Fan Blows But the Outside Compressor Doesnt Come On

Since its introduction to the automotive world in the 1940 Packard, air-conditioning systems have been through many changes. The most drastic change was the shift from R12 to R134a, due to environmental concerns. When you turn on the air conditioner by pressing the power button and turning on the fan, you expect to hear the compressor kick on. There are six main reasons for the compressor not to turn on when you expect it to.

Incorrect Charge Level

    All air-conditioning systems use a refrigerant to cool the cabin of the vehicle -- either R134a or R12. All post-1996 vehicles use R134a and prior to that, most vehicles used R12 refrigerant, commonly called Freon. The air-conditioning system requires a specific amount for refrigerant to run without causing damage. If the charge is low, most cars cut off power to the compressor to keep it from turning on.

Failed Pressure Sensor

    Air-conditioning systems are under high pressure -- some exceed 200 psi. If the system has too much or too little pressure, damage may occur. Most modern vehicles use an air-conditioning pressure switch to monitor the pressures and cut power to the compressor if the pressures are incorrect. If this switch fails, no power can get to the compressor and it will not turn on.

Failed Wiring

    The air-conditioning systems in all cars have a series of power and ground wires. If one of these wires fails, the compressor cannot receive power and will not turn on. This failed wiring can also cause additional problems with your vehicle.

Failed Air Conditioning Switch

    To engage the air conditioner, you must press a switch inside the vehicle. If the electronics inside this button fails, the compressor will not turn on, as it will not receive power.

Blown Fuse

    As with all electric systems in vehicles, there is a fuse that protects the compressor from power overload, typically 10 to 30 amps. If the amperage exceeds the limits of the fuse, it will break the circuit and the compressor will no longer receive power.

Failed Compressor

    The compressor has a clutch on the front that engages and disengages as you turn the air conditioning on and off. If this clutch fails, it causes the compressor to either lock up or spin freely. If the latter is true, the compressor cannot turn on, as the power is not transferring from the drive belt to the compressor. If the former is true, the pulley locks up with the compressor and you will hear a loud screeching sound from the belt spinning on the stuck pulley.

Read More.. >