Showing posts with label town. Show all posts
Showing posts with label town. Show all posts

Friday, May 16, 2014

How to Troubleshoot a 1996 Chrysler Town Country

The base model of the 1996 Chrysler Town and Country minivan came equipped with a 3.3 liter six cylinder engine. The van included several different standard features including bucket seats, passenger seating for seven, an overhead console, cruise control, power steering, a tilt steering wheel, air conditioning, 15 inch wheels, power door locks and a trip computer. Because the Town and Country is comprised of so many different parts it can be difficult to know what repairs or changes to make. One way to troubleshoot the van is by working through general troubleshooting techniques.

Instructions

    1

    Look at the fuel line assembly of the Town and Country if you smell gas fumes inside the passenger compartment of the van while you are driving. There could be a loose or damaged fuel line or fuel line connector. There could also be a leaky fuel filter or the fuel tank could be punctured or damaged and leaking fuel. You should also inspect the canister purge valve of the fuel system to ensure that it isnt leaking. Make sure that the carburetor and fuel injectors inside the engine are not worn, dirty or malfunctioning.

    2

    Check the vans M.A.P. sensor when the engine has an erratic idle. Make sure the sensor is still working properly. Find the EGR valve and look to see if it has become faulty or not too. The fuel injectors could also be dirty or worn or the idle air control valve and idle speed actuator to ensure that they are not damaged, faulty or loose. The throttle position sensor could be incorrectly connected or faulty and the fuel filter could be clogged or dirty. Be sure to also inspect the PCV valve, carburetor, exhaust valves, timing gear, fuel pump, camshaft and ignition points to determine if any of these parts needs to be repaired or replaced.

    3

    Look at the differential system of the Town and Country when you hear a groaning noise coming from underneath the van while you are driving. You could have a low differential fluid level. You may also have a worn or damaged differential bearing or the wrong type of differential fluid inside the system. If you hear the groaning noise coming from the engine compartment while you are turning your steering wheel, look at the steering pump and power steering cylinder to ensure that they are not faulty. You should also check the power steering hose to make sure that it has been correctly installed and is not leaking.

Read More.. >

Monday, October 21, 2013

Lincoln Town Car Alignment Specifications

Lincoln originally introduced the Town Car as a trim of the 1969 to 1971 Continental. It became a separate model in 1972 and has since been Lincolns most recognized and successful sedan. It is known not only for the performance of its V-8 engine, but also for its comfortable ride and its wide, spacious six-person seating. The current generation of the Town Car rolled out in 2003. The alignment specs for all trims of the 2010 Lincoln Town Car are the same, and the alignment cannot be adjusted on the rear wheels.

Caster

    The caster angle is the measurement of a positive or negative slope in line between the upper and lower steering pivots in a wheel when looking at it from the side of the vehicle. The caster angle is measured in degrees. The limits for the caster angle in the 2010 Lincoln Town Car are +5.45 degrees to +6.95 degrees. The ideal setting for the caster angle is +6.2 degrees.

Camber

    The camber is the angle that the tire slants when looked at from the front of the car. If the top of the tire looks like it is tilting inward toward the cars engine, then the camber angle is negative. If it tilts outward away from the engine, then the camber angle is positive. Like the caster angle, the camber angle is measured in degrees. The limits for the camber angle in the 2010 Lincoln Town Car are -1.35 degrees to +.15 degrees, and the ideal setting for the camber angle is -.6 degrees.

Toe-in

    The front wheels of many vehicles are angled slightly toward each other at their fronts to help take pressure off of the vehicles suspension. This inward angle is referred to as the "toe-in" and is the measurement of the exact angle the wheels sit in relation to the centerline of the vehicle when viewed from above. The toe-in can also be presented in inches by measuring the distance between the fronts of the two front tires and the distance between the backs of the two front tires, with the difference being the toe-in. The limits for the toe-in in the 2010 Lincoln Town Car are +.13 degrees to +3.7 degrees. The 2010 "Motor Auto Repair Manual" suggests performing a ball-joint inspection when calculating or adjusting the toe-in.

FYI

    Please keep in mind that the alignment specs for a vehicle change from year to year, as well as from model to model. Be sure to check your owners manual or speak with a certified mechanic before making any significant repairs or adjustments to your vehicle.

Read More.. >